Agilent Technologies 5975 Series User Manual

3 Intuvo 9000 GC Column Maintenance
5975/5977 Series MSD Operating Manual 73
The 9000 GC/MS Tail is heated by an electric cartridge heater. The heater is
powered and controlled by a heated zone of the 9000 GC. The 9000 GC/MS Tail
temperature can be set from the Agilent MassHunter GC/MS Acquisition
software or from the GC. A sensor (thermocouple) in the interface monitors the
temperature.
The transfer line tip seal assembly is required when using the EI XTR source or
the HES.
The 9000 GC/MS Tail should be operated in the 250  to 350 C range. Subject to
that restriction, the transfer line temperature should be slightly higher than the
column temperature, but never higher than the maximum column temperature.

Agilent Technologies 5975 Series Specifications

General

Brand	Agilent Technologies
Model	5975 Series
Category	Laboratory Equipment
Language	English