SCPI COMMAND SUMMARY
Sets and queries the CW frequency. This do es not change the
swept/CW mo de switch. *RST value is (MAX + MIN)/2 .
See
FREQ:CENTER
for more information.
FREQuency[:CW]:AUTO ON|OFF|1|0
FREQuency[:FIXed]:AUTO ON|OFF|1|0
FREQuency[:CW]:AUTO?
FREQuency[:FIXed]:AUTO?
Sets and queries the CW/center frequency coupling switch. This
switchkeeps the two functions coupled together when
ON
. Changing
one of them, changes both. *RST setting is
OFF
. See
FREQ:CENTER
for more information.
FREQuency:MANual <num>[freq
suffix]|MAXimum|MINimum|UP|DOWN
FREQuency:MANual? [MAXimum|MINimum]
Sets and queries the manual frequency. This controls the output
frequency in swept manual mo de. The limits are START and STOP.
*RST value is the same as
FREQ:CENTER
. See
FREQ:CENTER
for more
information.
FREQuency:MODE FIXed|CW|SWEep|LIST
FREQuency:MODE?
Sets and queries the switch that selects either swept, CW or list
operation. *RST value is CW.
FREQuency:MULTiplier <num>|MAXimum|MINimum
FREQuency:MULTiplier? [MAXimum|MINimum]
Sets and queries the frequency multiplier. The numeric value is
rounded to the nearest integer. This function changes mapping of
frequency parameters on input to and output from the sw
ept signal
generator. Changing this does not aect the output frequency of the
swept signal generator. Only the displayed parameters and query
responses are changed.
The equation implied by this is :
Entered/displayed frequency = (Hardware Freq * Multiplier ) + Oset
After *RST, the value is 1.
FREQuency:MULTiplier:STATe ON|OFF|1|0
FREQuency:MULTiplier:STATe?
Queries and turns the frequency multiplier o and on.
After *RST, the setting is OFF.
FREQuency:OFFSet <num>|MAXimum|MINimum
FREQuency:OFFSet? [MAXimum|MINimum]
Sets and queries the frequency oset. This function c
hanges the
S-36 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
