Agilent Technologies 8712ET

10-68 Programmer’s Guide
Menu Map with SCPI Commands
Menu Map for 8712ET/ES and 8714ET/ES
Table 10-28 SYSTEM OPTIONS Functions, 8712ET/ES and 8714ET/ES (7 of 9)
KEYSTROKES SCPI COMMAND
SYSTEM OPTIONS, Sys Config, (continued)
Alpha DISP:ANN:CLOC:DATE:MODE ALPH
Seconds ON off DISP:ANN:CLOC:SEC [ON|OFF]
Beeper Volume (enter value,
press Enter)
SYST:BEEP:VOL <num>
CRT Adjust (menu selection only)
Restore Defaults (no SCPI command)
Vertical Position (no SCPI command)
Horizontal Position (no SCPI command)
Sync Green on OFF (no SCPI command)
Remove Pattern (no SCPI command)
Restore Defaults (no SCPI command)
Vertical Back Porch (no SCPI command)
Vertical Frnt Porch (no SCPI command)
Horizontal Back Porch (no SCPI command)
Horizontal Frnt Porch (no SCPI command)
Options Setup (menu selection only)
Install Option (enter keyword,
press Enter)
(no SCPI command)
Special Option (enter key,
press Enter)
(no SCPI command)