11-34 Programmer’s Guide
SCPI Command Summary
SCPI Device Command Summary
Table 11-15 OUTPut
Table 11-16 POWer
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
SUBSYSTEM COMMANDS FORM DESCRIPTION
OUTPut[:STATe] <ON|OFF>
1
NR1 Turns RF power from the source
on/off.
SUBSYSTEM COMMANDS FORM
DESCRIPTION
POWer[1|2]:MODE <char> CHAR Specifies either frequency sweep
(FIXed) or power sweep (SWEep).
To Next Page
Loading...
