HP IBASIC Supplement 1-3
Introduction
Overview of HP Instrument BASIC
Overview of HP Instrument BASIC
HP Instrument BASIC (IBASIC) can be used for a wide range of
applications, from simple recording and playback of measurement
sequences to remote control of other instruments. IBASIC is a complete
language with over 200 keywords.
IBASIC is a complete system controller residing inside your analyzer. It
communicates with the analyzer via GPIB commands over an internal
interface bus (select code 8). It can also communicate with other
instruments, computers, and peripherals using the external GPIB
interface (select code 7) or the serial (select code 9) or parallel (select code
15) I/O ports.
NOTE The analyzer can also be controlled by an external controller. It has a
factory default external GPIB address of 16. When using IBASIC to
control other instruments, no other device should use the same
address.The external GPIB address can be changed using either the
front panel keys under the , menu, or the
SCPI mnemonic SYST:COMM:GPIB:ADDR.
SYSTEM OPTIONS
To Next Page
Loading...
Need help?
General
