Agilent Technologies Agilent 33500 Series

LXI Subsystem
LXI:RESTart
Restarts the LAN with the current settings as specified by the SYSTem:COMM:LAN commands.
Parameter Typical Return
(none) (none)
Restart the LANinterface:
LXI:REST
l Depending on your network, the LAN interface may take several seconds to restart after this command is sent.
l If the LAN interface or specific LAN services (VXI-11, sockets, and so on) have been disabled by SYS-
Tem:COMMunicate:ENABle, you must separately re-enable the interface or services and cycle power on the instru-
ment for the LAN to be operational.
Agilent 33500 Series Operating and Service Guide 243