3-4
Replaceable Parts
Assemblies and Hardware Options
Shipping a Defective Assembly Back to Agilent Technologies
1. When you receive the rebuilt assembly, be careful not to damage the box in which it was shipped.
You will use that box to return the defective assembly. The box you receive should contain the
following:
• the rebuilt assembly
• an exchange assembly failure report
• a return address label
2. Complete the failure report.
3. Place the failure report and the defective assembly in the box. Be sure to remove the enclosed
return address label.
4. Seal the box with tape.
If you are inside the United States, stick the pre-printed return address label over the label that
is already on the box and return the box to Agilent Technologies. (Agilent Technologies pays
postage on boxes mailed within the United States.)
If you are outside the United States, do not use the return address label; instead, address the
box to the nearest Agilent Technologies sales and service office.
To Next Page
Loading...
Need help?
General
