Agilent Technologies G1314B - System Preparation and Module Activation

56 Agilent 1260 Infinity VWD User Manual
4 Using the Detector
Setting up an Analysis
Preparing the HPLC System
1 Turn on the Agilent ChemStation PC and the monitor.
2 Turn on the modules.
3 Start the Agilent ChemStation software. If the pump, autosampler,
thermostatted column compartment and detector are found, the Agilent
ChemStation screen should look like shown in Figure 14 on page 56.
The System status is red (Not Ready).
Figure 14 Initial Agilent ChemStation screen (Method and Run Control)
HnhiZbhiVijh
Dca^cZeadil^cYdl
YZiV^ahl^cYdl