Agilent Technologies Intuvo 9000 - Page 83

Installing the GC 1
Agilent Intuvo 9000 GC Installation 83
5
Secure the column by using the Intuvo torque driver to close
the column clamps.
6 Insert the column’s Intuvo Smart ID Key into the lower USB
connection along the right side of the oven.
e Close the oven door.
f Install the bus door.
7 Install the bus door. Place the torque wrench back in the
front door of the instrument.
NOTE
Do not tighten the column clamps until after the column connections are
properly tightened with the torque wrench.