Multimeter Setup Options 4
Setup Menu Items
U1231A/U1232A/U1233A User’s Guide 93
Changing the minimum measurable frequency
This setting is used with frequency tests (see page 62).
Changing the minimum measurable frequency will influence
the display update rates for frequency measurements. The
typical display update rate as defined in the specification is
based on a minimum measurable frequency of 0.5 Hz.
Use this Setup item to adjust the minimum measurable
frequency value (either 0.5 Hz or 5.0 Hz).
Figure 4-10 Changing the minimum measurable frequency
Changing the continuity test alerts
This setting is used with continuity tests (see page 41). You
can set the beeper to sound and the backlight to flash as a
continuity indication whether the circuit- under- test is less
than (short) or more than or equal to (open) the threshold
resistance.
Parameter Range Default setting
FrEq 0.5 Hz or 5.0 Hz 0.5 Hz
To Next Page
Loading...
Need help?
General
