Agilent Technologies U1252B - Setting Data Hold;Refresh Hold Mode; Figure 4-1 Data Hold;Refresh Hold Setup

78 Agilent U1251B/U1252B User’s and Service Guide
4 Changing The Default Setting
Setting Data Hold/Refresh Hold Mode
1 Set OFF to enable the Data Hold mode (manual trigger by
key or bus via the remote control).
2 Set the variation count within the 100~1000 range to
enable the Refresh Hold mode (auto trigger). When the
variation of the measuring value exceeds the setting of the
variation count, the Refresh Hold will be ready to trigger.
Figure 4-1 Data hold/Refresh hold setup
Press
Press
Press
Press
Press