Agilent Technologies Velocity11 VSpin User Manual

Chapter 1: Introductione(V
VSpin User Guide
Safety Information
Before installing and using the VSpin
Before installing and using the VSpin, make sure you are aware of the
potential hazards and understand how to avoid being exposed to them. You
must be properly trained in the correct and safe installation and operation of
the device.
Intended product use
!! INJURY HAZARD !! Do not remove the VSpin exterior covers or otherwise disassemble
the product. Doing so can expose you to hazards that could cause serious injury and damage
the VSpin.
!! INJURY HAZARD !! Using controls, making adjustments, or performing procedures
other than those specified in the user guide can expose you to moving parts and hazardous
voltage.
Agilent Technologies products must only be used in the manner described in
the Agil
ent Technologies product user guides. Any other use may result in
damage to the product or personal injury. Agilent Technologies is not
responsible for any damages caused, in whole or in part, by improper use of
the products, unauthorized alterations, adjustments or modifications to the
products, failure to comply with procedures in Agilent Technologies product
user guides, or use of the products in violation of applicable laws, rules or
regulations. Except as otherwise expressly provided in Agilent Technologies
product user guides, any alteration, adjustment, or modification to the products
will void the product warranty.
The VSpin is not intended or approved for diagnosis of disease in humans or
anim
als. You
assume full responsibility for obtaining any regulatory approvals
required for such use and assume all liability in connection therewith.
Safety features
The VSpin has been designed to maximize safety with the following safety
features:
• The VSpin will not spin unless:
– The door is closed and locked.
– The buckets are unlocked.
– The buck
et payl
oads are balanced.
– The appropriate software command is sent.
• The VSpin door will not unlock or open if the spindle is moving.
Moving parts
!! INJURY HAZARD !! Never attempt to touch any of the moving parts or remove plates
while the VSpin is in operation. It is not possible to touch the rotor while it is in motion, if the
door is functioning properly, but the door can cause possible pinching, piercing or bruising
when it closes.

Agilent Technologies Velocity11 VSpin Specifications

General

Brand	Agilent Technologies
Model	Velocity11 VSpin
Category	Laboratory Equipment
Language	English