Agilent Technologies Velocity11 VSpin User Manual

Chapter 3: Installation
VSpin User Guide
22
Installation Overview
Installation
Procedures
The procedures you need to perform to properly install your VSpin are
listed in order in the following table.
Step Procedure See...
1.
Verify that your lab meets the
necessary requirements
“Laboratory Requirements” on
page 23
“Preparing the Mounting Surface”
on page 26
2.
Unpack the VSpin “Unpacking the VSpin” on
page 24
3.
Install the buckets “Installing the Buckets” on
page 31
4.
Prepare to install the VSpin “Preparing the Mounting Surface”
on page 26
5.
Install the VSpin “Mounting the VSpin” on page 29
6.
Connect air and power sources “Connecting to Air and Power
Sources” on page 33
7.
Connect to the computer “Connecting to the Computer” on
page 35
8.
Install the software “Installing the Software” on
page 36
9.
Create a Profile “Creating and Managing Profiles”
on page 37
10.
Teach the bucket alignment so
that it lines up with the door
“Aligning the Buckets” on page 40

Agilent Technologies Velocity11 VSpin Specifications

General

Brand	Agilent Technologies
Model	Velocity11 VSpin
Category	Laboratory Equipment
Language	English