47
Chapter 4: Performing a Spin
VSpin User Guide
Turning on the VSpin
Procedure To turn on the VSpin:
1. Verify that the air and power are connected to the VSpin and to their
sources.
2. Verify that the serial communications cable is connected to the
VSpin and to the computer.
3. Turn the power switch on.
To verify that the VSpin has power, you must start the VSpin
Diagnostics software. See “Starting the Software” on page 48.
There are no outwardly observable signs that the VSpin has power.
Where to Go Next Before you start a spin, refer to the “Workflow Overview” on page 46 to
prepare your VSpin.
To Next Page
Loading...
Need help?
General
