ahlmann AL 65 - Page 64

4-4 K65C/K75C/K95C 4-4 K65C/K75C/K95C
Inching
(option)
The inching pedal is located next to
the left-hand service brake pedal.
By stepping on this pedal, the
driving speed can be reduced to a
standstill while the engine speed is
retained. The continuously adju-
stable inching function is required if
a high lifting speed (high diesel
engine speed) is required at low
driving speeds (inching).
Electrical system
2 headlights, front
2 working lights, front
2 working lights, rear
Hazard flasher
Interior lighting
1 plug socket, 7-pin, front
Rear window heater
Battery main switch
Signal horn
Reverse warning system (opt.)
Radio system (opt.)
Warning beacon (opt.)
Heatable rearview mirror (opt.)
Transponder for drive-away
interlock (opt.)
(opt. = option)
Battery
The battery compartment contains a
maintenance-free battery (4-5/
arrow) with an increased cold start
performance. The battery is to be
kept clean and dry. Lightly grease
the terminals with acid-free and
acid-resistant grease.
CAUTION
Electric arc welding on the loader
is only to be performed when the
battery main switch (4-11/3) has
been disconnected.
Figure 4-5
Inching
(option)
The inching pedal is located next to
the left-hand service brake pedal.
By stepping on this pedal, the
driving speed can be reduced to a
standstill while the engine speed is
retained. The continuously adju-
stable inching function is required if
a high lifting speed (high diesel
engine speed) is required at low
driving speeds (inching).
Electrical system
2 headlights, front
2 working lights, front
2 working lights, rear
Hazard flasher
Interior lighting
1 plug socket, 7-pin, front
Rear window heater
Battery main switch
Signal horn
Reverse warning system (opt.)
Radio system (opt.)
Warning beacon (opt.)
Heatable rearview mirror (opt.)
Transponder for drive-away
interlock (opt.)
(opt. = option)
Battery
The battery compartment contains a
maintenance-free battery (4-5/
arrow) with an increased cold start
performance. The battery is to be
kept clean and dry. Lightly grease
the terminals with acid-free and
acid-resistant grease.
CAUTION
Electric arc welding on the loader
is only to be performed when the
battery main switch (4-11/3) has
been disconnected.
Figure 4-5