Aiways U5 2021 - Intelligent Front Camera (IFC)

Intelligent Front Camera (IFC)
When the following conditions occur, the intelligent front camera must be recalibrated (hereinafter
referred to as "camera"):
●
The camera position changes due to the disassembly and assembly of the camera or the front
windshield;
●
The calibration data of the camera is lost after an accident.
NOTE: When the camera reports a fault due to dirt or blockage, the instrument will prompt the
troubleshooting information such as cleaning up dirt, please pay attention.
Working conditions affecting the camera detection performance include but are not limited to:
●
Severe weather such as heavy fog, heavy rain, heavy snow, dust, sandstorms and other weather with
low visibility;
●
Bad lighting conditions: weak light or strong light, such as at night, in underground parking lots,
reflective roads due to rain or snow, lights of vehicles driving in the opposite direction, sudden changes
in lighting conditions, such as tunnel entrances and exits;
●
The camera is not fixed in place; the camera is partially or completely blocked by coverings such as
foreign matters and stains;
●
The front windshield is dirty, foggy, and frosted.
NOTE:
●
When the camera is partially or completely blocked by foreign matters, stains and other coverings and
cannot work properly, you can wipe or clean the front windshield according to the prompt information
of the instrument.
●
In the wet and cold environment, the front windshield and the surface of the camera are prone to water
drops to blind the camera, you shall defrost and defog the front windshield and dry the glass surface
first.
Blind spot detection radar (BSR)
AIWAYS U5 | 103