current speed as the target speed of ACC. Release the pedal to complete ACC target speed adjustment
settings.
●
Short press the “RES/+” or “SET/-” button once to gradually increase or decrease the target speed by
a value of 5 km/h (3 mph) each time. Long press the “RES/+” or “SET/-” button and the target speed
will increase or decrease rapidly by a value of 1 km/h (1 mph) each time. Release the button to complete
the ACC target speed adjustment settings.
CAUTION: In the process of target speed adjustment of the ACC, the speed difference of the deceleration
adjustment has a limit, and the speed cannot be reduced from a higher one to a lower one without
limitation. If it is necessary to reduce the speed immediately in case of emergency, the driver needs to
actively intervene in braking and deceleration; in the process of rapid adjustment of target speed, when
the vehicle is close to the vehicle ahead and the target speed is not reached, the instrument may pop up
a "brake" prompt. The driver should always pay attention to the road conditions while receiving the
instrument prompt information, and be ready to take over the vehicle at any time and prepare for active
braking.
ACC following time interval adjustment
The following time interval is a timed distance (current speed × time) rather than a fixed distance, and
changes with the current speed. The following time interval is classified into 8 levels, and the time span
is from 1.5 seconds to 3 seconds, which can be adjusted by the driver by scrolling the left roller of the
steering wheel up and down.
AIWAYS U5 | 133
To Next Page
Loading...
