Camera and recognition systems
Reverse image
If your car is equipped with the reverse image function, put your car in reverse gear when positioning your
vehicle in the parking space near the destination. At this time, the console screen will enter the reverse
image display mode to facilitate your parking.
During parking, you can adjust the steering wheel angle based on the dynamic changes of the assistance
line. The distance between vehicle and obstacles is indicated by white, yellow and red. If your car is
equipped with radar devices at the front and rear bumpers, the alarm sounds will become increasingly
shorter as the distance between the vehicle and the obstacle gets closer during parking. Please pay close
attention to the distance change prompt.
CAUTION: When the speed is higher than the threshold, the reverse image function will exit and remind
you to drive carefully. You can swipe up, down, left and right with two fingers to exit the reverse image
interface.
NOTE: Exit the reverse gear under the reverse image interface. When the vehicle speed reaches the
threshold, the reverse image interface will automatically close.
Panoramic image
If your car is equipped with a panoramic image, you can enter the panoramic image mode using the
corresponding menu on the console screen, or you can press the "*" button on the steering wheel (need
to define panoramic image function in advance) to enter the panoramic image mode. Click the
corresponding view button of panoramic image interface to switch the perspective of panoramic image
interface; click the 3D view switch button to switch between 2D view mode and 3D view mode.
PATH: Settings - Direction control - Customized direction control「*」button
On the panoramic image interface, you can swipe up, down, left and right with two fingers to exit the
current interface.
WARNING:
AIWAYS U5 | 161
To Next Page
Loading...