Tyre specification Standard tyre pressure
215/65 R17 99V 260 kPa / 2.6 bar
235/50 R19 99V 260 kPa / 2.6 bar
Check tyre pressure of cold tyres regulary, especially before long trips.
Incorrect tyre pressures will endanger your safety, vehicle handling, comfortness and power range and will
also increase tyre wear.
When the vehicle is fully occupied, you shall increase the tyres’ pressure to its full load value.
Too low pressure causes overheating of the tyre, which may result in internal damage of the tyre and even
a tyre flat.
Winter tyres
Tyre size 235/50 R19 99V is permitted as winter tyre. Mount winter tyres on all wheels.
Winter tyres should be used when the temperature is permanent below 7° C.
When your winter tyres are speed restricted, fix a max. speed sticker on the combination instrument in
driver’s field of view.
Tyre Inspection and Maintenance
It is recommended to install the tyres with the same specifications as the original ones when replacing. If
you replace the tyres with ones with different specifications or unqualified ones, it may have an adverse
impact on the driving performance and driving safety of the vehicle. When there is a certain wear
phenomenon on the tyre surface, it is advantageous to change the tyre crosswise.
In the case of obvious wear of front wheels, it is recommended to adjust the position of the front and rear
wheels, so as to prevent uneven wear of tyres, prolong the service life of tyres and make the tyre fatigue
uniform. To balance the use of all tyres on the vehicle, it is recommended to change the tyres crosswise
every 5000km.
116 | AIWAYS U5
To Next Page
Loading...
