After the SLF is halted, if it is always in ON state, reactivate the function by pressing the “RES/ +” button.
The maximum speed limit will be the same as it was before it was cancelled.
Off: When the SLF is on or activated, press the “speed limit function” button again to turn off the SLF.
Override: After the SLF is activated, if it is necessary to accelerate in case of emergency, the driver can
quickly press hard on the accelerator pedal. In this case, the SLF will enter override mode, and the vehicle
speed will temporarily increase to exceed the maximum speed limit; when the driver releases the
accelerator pedal, the speed will slowly drop back below the maximum speed limit.
CAUTION: When the SLF is in the override state, the vehicle will always be in a state of rapid acceleration.
The driver needs to pay special attention and be calm.
Forward-looking Centre Radar (FCR)
When the following situations occur, the forward-looking centre radar must be recalibrated (hereinafter
referred to as "radar"):
●
The radar has an out-of-alignment failure such as the disassembly or assembly of the front anti-collision
beam, radar or radar bracket, which has caused the radar position to change;
●
The vehicle's four-wheel alignment parameters or driving axis changes.
NOTE:
●
When the vehicle encounters a slight impact or strong vibration, the radar position may change. To
ensure that the system works properly, please contact Aiways to recalibrate the radar.
●
When the radar fails, the instrument will pop up the corresponding prompt message, please pay
attention.
Working conditions affecting the radar detection performance include but are not limited to:
●
The radar is covered or obscured by mud, snow, heavy rain or water splashes;
●
Environmental factors such as highway guardrails and tunnel entrances;
●
The radar is subject to strong electromagnetic interference.
102 | AIWAYS U5
To Next Page
Loading...
