●
If the instrument displays the icon of the rear of the vehicle ahead, it indicates that the ACC is
performing following cruise; if the instrument does not display the icon, it indicates that the ACC will not
respond to the vehicle ahead.
●
During following cruise, if the accelerator pedal is stepped on, the instrument will prompt "the driver is
overriding". During this period, the ACC will be in overriding state, unable to automatically apply the
brake to the vehicle.
●
When the ACC controls the vehicle to brake to a stop, it will actively activate the electronic parking brake
function if the driver releases the seat belt or opens the door; if the ACC exits by other means (such as
stepping on the brake pedal or pressing the "CNCL" button to cancel the ACC), it will not activate the
electronic parking brake function, the ACC function will exit, and the vehicle will enter Crawl Control.The
driver needs to pay special attention to avoid personal injury.
When ACC is activated, the following conditions shall be met simultaneously:
●
The gear is in drive;
●
The brake pedal is not pressed down;
●
The electric parking brake is released;
●
The seat belt on the driver's side is fastened;
●
All vehicle doors are closed;
●
The front compartment hood is closed;
●
The ESP is turned on;
●
The hill descent control function is OFF;
●
The auto hold is not activated.
ACC target speed adjustment
When ACC is activated, the cruise target speed can be increased or decreased by the following methods:
●
The driver presses the accelerator pedal to quickly increase the vehicle speed to the desired speed, and
at the same time short presses the “SET/-” button to set the current speed as the target speed of ACC;
the driver steps on the brake pedal (ACC will enter standby state) to quickly reduce the vehicle speed
to the desired speed, and after releasing the brake pedal short presses the “SET/-” button to set the
132 | AIWAYS U5
To Next Page
Loading...
