1. After the vehicle is started, press the “iDrive mode” button on the steering wheel (switchable between
the “iDrive/ACC/SLF” mode) to switch to ACC and enter the standby (ready) state. The ACC ON
indicator lamp (white) on the instrument will light up and display “ACC ready.”
2. After ACC activation conditions are met, press the “SET/-” button on the steering wheel. ACC then
enters its activated state and the ACC activation indicator lamp (green) on the instrument will be on and
display “ACC activated.”
NOTE: If the current speed is greater than 30km/h (20mph), the ACC target speed is the current speed.
If the current speed is less than 30km/h, the ACC will control the vehicle to accelerate to 30km/h and take
30km/h as the ACC target speed.
After ACC is activated, if a vehicle is detected ahead in the same lane as the vehicle, the acceleration and
deceleration of the vehicle ahead will be automatically copied by the system to maintain distance from the
vehicle ahead:
●
If the speed of the vehicle ahead is greater than the speed of your vehicle, the vehicle will maintain the
current speed and ACC will switch to cruise control. If the speed of the vehicle ahead is less than the
speed of the vehicle, the vehicle will reduce its speed, and ACC will switch to following cruise.
●
If the vehicle ahead brakes and stops, ACC controls the vehicle to follow accordingly until it stops. If the
vehicle ahead stops for less than 10 seconds, the vehicle will follow automatically once it starts again.
If the vehicle ahead stops for more than 10 seconds, the vehicle will not start and follow automatically.
If the system detects that the vehicle ahead has left the lane, the driver can follow the prompt “Step on
accelerator or press RES/+ to activate cruise” on the instrument panel, press the accelerator pedal or
press the “RES/+” button to reactivate ACC.
WARNING: Do not leave the vehicle when the ACC controls the vehicle to be stationary. If you need to
leave, be sure that the electric parking brake is in the pull-up state, put the gear in the parking gear, and
leave after the vehicle is powered off.
WARNING:
●
After the ACC controls the vehicle to follow and stop, when starting and following again, make sure that
there are no obstacles or pedestrians and other traffic participants directly in front of the vehicle.
AIWAYS U5 | 131
To Next Page
Loading...
