2. Push the child safety seat anchor bars into the installed connectors until you hear a “click.”
3. Pull the child safety seat to check that it has been securely fixed.
Top-tether anchor fixation
Top-tether anchors are additional mounting points on the rear side of the backrest.
If your vehicle is equipped with mounting points for ISOFIX or i-Size fixture systems, which can be found
on either side of the back seat, you can install the child safety seat in the back seat.
1. Attach the base of the child safety seat to the ISOFIX or i-Size anchorage point at the bottom of your
vehicle seat; you should hear a “click.”
2. Pull the top tether strap of the child safety seat across the back of the headrest, and attach it to the
anchorage point on the safety device that can be found on the top part of the back seat. Tighten the
strap.
3. Pull on the fixed child safety seat to make sure it is securely installed.
For detailed installation instructions, please refer to the user guide that comes with the child safety seat.
“ISOFIX” anchor points can also be retrofitted to the vehicle later.
WARNING:
●
The anchor rings are specially developed for ISOFIX child safety seats. The Child Restraint Fixtures
(CRFs) should only be used for ISOFIX child safety seats. Please do not fix other types of child safety
seats,
seatbelts or objects to the anchor rings, as it could lead to fatal injuries!
●
When installing/uninstalling the seat, always follow instructions from both the child safety seat
manufacturer and vehicle manufacturer. Improper operation could lead to injuries to children or other
occupants.
●
ISOFIX child seats currently can be used for children weighing 9kg–18kg, approximately aged between
9 months and 4 years old.
40 | AIWAYS U5
To Next Page
Loading...
