Aiways U5 2021 - Intelligent High Beam Control (IHBC)

WARNING:
●
The LKA function is a driver assistance function, which can remind and appropriately intervene in the
lane departure behavior.
Even if the LKA function is equipped, the driver must still concentrate, hold the steering wheel, drive
carefully, and always observe the road conditions to avoid accidents.
●
Please set the LKA function in an environment where the vehicle is stationary and safety is ensured.
●
The LKA function may have errors in the recognition of lane lines, mistakenly identifying poor
pavements, some road structures or objects as lane lines.
When the vehicle is driving abnormally for this reason, please take over the vehicle immediately, brake
and decelerate and keep the vehicle running steadily. It is recommended to turn off this function when
vehicles pass through poor road sections or road construction sites.
●
Severe weather conditions such as rain, snow, smoke, hail, sand, and backlight will affect the stability
of the LKA function. It is not recommended to use the LKA function in severe weather.
●
During the operation of the LKA function, the driver's intense driving actions such as making a sharp
turn and changing lanes and stepping on the accelerator will suppress the LKA function.
●
In case of complex traffic conditions such as merging, lane change, cut-in, cut-out, intersection, etc., it
is recommended that the driver actively take over the vehicle and keep the vehicle running stably.
NOTE:
●
The LKA function depends on the activation of LDW function, and it can work normally after activation
of both at the same time.
●
When using the LKA function initially, the driver has no psychological expectation of the system
intervention, the intervention force of subjective feeling may be too large, and the intervention time
may be too late. This belongs to the normal setting of the system. After the driver is familiar with the
system operation, he/she can use the LKA function proficiently.
Intelligent High Beam Control (IHBC)
When the IHBC function is switched on, turn the knob on the light control lever to the “Auto” position. If
the speed is higher than 40 km/h, the IHBC function can automatically control the status of the high beam
AIWAYS U5 | 149