Instruction on automatic positioning of tyre pressure sensor
BCM needs to receive four-wheel speed signal and speed pulse signal etc. from ESP module, which will be
used in automatic positioning of tyre pressure sensor. When the vehicle runs at a speed over 30km/h, the
sensor will send radio-frequency signal data periodically. After the vehicle running, BCM will activate the
automatic positioning function. Keep the vehicle running for 10 minutes, and check if the instrument
displays pressure readings of four tyres. If the pressure readings of four tyres are normally displayed, it
means the alignment is successful. If the pressure readings are not complete or there is no pressure
reading, stop the vehicle for not less than 19 minutes. Then, while reactivating the automatic positioning
function, run the vehicle on an 8-shape trace till the four tyre pressure readings are normally displayed.
Seasonal Tyre Types
Summmer Tyre
Your vehicle may be originally equipped with high performance summer Tyres or all-season Tyres. Aiways
recommends using winter Tyres if driving in cold temperatures or on snowy or icy roads. Contact Aiways
for winter Tyre recommendations.
All-season Tyres
Our U5 may be originally equipped with all-season Tyres. These Tyres are designed to provide adequate
traction in most conditions year-round, but may not provide the same level of traction as winter Tyres
provide in snowy or icy conditions. All-season Tyres can be identified by "ALL SEASON "and/or"M+S"(mud
and snow) on the Tyre sidewall.
AIWAYS U5 | 119
To Next Page
Loading...