NOTE: B-call road rescue services are not available in all regions.
Jump starting
Your car is equipped with a smart charge function. When the 12 V voltage battery is low, the vehicle's
power battery will start to charge the 12 V voltage battery. If the 12 V voltage battery often suffers from
abnormal power shortage, please immediately contact your Aiways service partner for maintenance.
WARNING:
●
Be very careful when starting with jump leads.
Any deviation from the following instructions can lead to injuries or damage caused by battery explosion
or damage to the electrical systems of both vehicles.
●
Never permute the electrical lead outs or interconnect the terminals.
●
Avoid contact of the battery with eyes, skin, fabrics and painted surfaces.
The fluid contains sulphuric acid which can cause injuries and damage in the event of direct contact.
●
When working on the battery, always wear eye protection and remove jewelry from your body.
●
Keep children away from the battery.
CAUTION: The smart charge function needs to meet specific conditions, and it is necessary for the front
compartment cover to be closed.
If the vehicle cannot be started normally due to power shortage in the low voltage battery, the low voltage
battery can be jump started for charging. The specific steps are as follows:
1. For parking and disconnection from the high-voltage power of the vehicle (hereinafter referred to as
“power off”), you can achieve active power off by using the control panel, or you can achieve passive
power off by locking the vehicle. Open the front compartment cover, remove the positive and negative
inspection covers of the 12 V voltage battery. Connect one end of the red cable to the positive pole of
the 12 V voltage battery in the power-shortage vehicle B and the other end to the positive pole of the
12 V voltage battery in the power supply vehicle A.
AIWAYS U5 | 125
To Next Page
Loading...
