25
5.1.3 Managing Clips
Basic clip editing and management can be done directly from the APC64 hardware using the following controls.
Use the CLEAR button to erase clips and scenes:
To erase a clip, press and hold the CLEAR button, and then press the
desired pad.
To erase an entire scene, press and hold the CLEAR button, and then press
the LAUNCH button for the desired scene. All clips in that row will be
removed.
Use the DUPLICATE button to copy clips and scenes.
To duplicate a clip, press and hold the DUPLICATE button, and then press
the desired pad. The clip and all its note and performance data will be
copied to the next clip slot below.
To duplicate a scene, press and hold the DUPLICATE button, and then
press the LAUNCH button for the desired scene. All clips in that row will be
copied to the next row below.
Note: If another clip or scene is in the next clip slot or row, its contents will be
overwritten by the duplicated clip or scene.
To double the length of a clip, press and hold both SHIFT and the DUPLICATE / DOUBLE button, and then
press the desired pad. The clip’s total length will instantly be doubled. If note or performance data is already
recorded into the clip, it will also be doubled to the new length.
Note: Audio clips cannot be doubled.
To Next Page
Loading...
Need help?
General
