34
5.3.4 Modifer Pads
The bottom-right quadrant of pads is used to set the velocity or other modifier
value for each note. By default, this controls the Velocity value of each step.
You can swap between viewing VELOCITY, PROBABILITY, or MUTATE by
pressing the Rows 1–3 LAUNCH buttons on the right side of the pad grid when
in Step Sequencer mode.
When Velocity is selected, the pads control the note dynamics as follows:
C5 C6 C7 C8
R5
103 111 119 Full
R6
71 79 87 95
R7
39 47 55 63
R8
As Played 15 23 31
When Probability is selected, the pads control the likelihood that the selected note is played, as follows:
C5 C6 C7 C8
R5
81% 87% 93% 100%
R6
56% 62% 68% 75%
R7
31% 37% 43% 50%
R8
3% 12% 18% 25%
When Mutate is selected, the pads determine whether a step will be played at its set pitch or be transposed up
or down within one octave, as follows. The specific notes are determined by the currently selected key and scale.
Note: Mutate is available for Note type Step Sequencer tracks only.
C5 C6 C7 C8
R5
81% 87% 93% 100%
R6
56% 62% 68% 75%
R7
31% 37% 43% 50%
R8
3% 12% 18% 25%
To Next Page
Loading...
Need help?
General
