105
Audio Tracks
All audio tracks in the project are grouped together in the lower half of the Track View.
To show or hide them, tap the or arrow icon.
Use the Input field to set the track’s input/inputs.
Use the Arm button to record-enable the track. When you begin audio recording, the audio signal will be recorded to
this track. You can select multiple tracks by pressing and holding Shift while tapping the Arm button to each track.
Use the Monitor button to set how your audio track will be monitored. Tapping it will cycle through its three states:
When set to Auto, you will hear incoming audio while the track is record-enabled only.
When on, you will hear incoming audio whether or not the track is record-enabled.
When off, you will never hear any incoming audio.
Use the level slider to change the level of the track. The level meter above the slider shows the track’s current level.
Use the pan knob to change the panning of the track.
Use the Solo and Mute buttons to solo or mute the track (respectively).
Alternatively, tap Mute or Solo (respectively) at the bottom of the touchscreen to mute the currently selected track.
Use the Add new audio track button to create a new audio track.
To Next Page
Loading...
Need help?
General
