60
Insert Effects
Pads
You can load up to four insert effects to each pad. You can do this in Main Mode, the Pad Mixer, or Program Edit Mode.
Tip: When using pad insert effects, they will be applied to the selected pad only. This means that you could apply
unique combinations of effects to each pad within a program. If you want to apply the same effect to all pads, do this
with a program insert effect (see Insert Effects > Programs).
To load a pad insert effect in Main Mode:
1. When the MIDI tab is selected (in the lower-left corner),
use the Track field to select the track that uses the
program with the desired pad—the program it uses will
be selected automatically.
2. If the channel strip is not already shown, tap the small
eye icon below the Project field to show it.
3. Tap the single-pad icon at the top of the channel strip.
The channel strip will now show settings for the current
pad.
4. Press the desired pad to select it. Alternatively, use the
Pad field at the top of the channel strip.
5. Tap the area under Inserts, and then use the screen that
appears to load or edit effects.
To load a pad insert effect in the Pad Mixer:
1. Use the Program field at the top of the touchscreen to
select the desired program. Alternatively, use the Track
field at the top of the touchscreen to select the desired
track—the program it uses will be selected automatically.
2. Press the desired pad to select it, or tap it in the
touchscreen. Alternatively, double-tap the Pad field
below the Program field.
3. Tap the area under Inserts, and then use the screen that
appears to load or edit effects. Alternatively, tap the
Insert tab at the bottom of the touchscreen (tap it
multiple times to select a different insert slot), and then
double-tap the desired pad in the touchscreen. You
could also use the data dial or –/+ buttons to select an
effect immediately.
To load a pad insert effect in Program Edit Mode:
1. While using the desired program, press the desired pad
to select it.
2. Tap the
Effects tab in the lower-right corner, and use it
to load or edit effects.
To Next Page
Loading...
Need help?
General
