6
Important Notes
Read the included safety & warranty manual before using MPC X.
Before getting started and connecting devices to MPC X or turning the hardware on/off, make sure all devices are
switched off.
To use MPC X in Controller Mode (to control the MPC software):
Before installing the MPC software, make sure your computer meets the system requirements described at
akaipro.com. This applies whether you’ll use MPC software as your host software or as a plugin in another digital
audio workstation (DAW).
Before connecting MPC X to your computer, install the drivers and software. Visit akaipro.com to download the
latest versions. Refer to the Installation section for more information.
Setup
1. Connection
Here is just an example of how to use MPC X in your setup. Items not listed under Introduction > Box Contents of
your included quickstart guide are sold separately.
Computer
Turntable
Microphone
Power
SD Card
(to front-panel SD card slot)
USB
drive
Powered Monitors
Footswitch
(to front-panel FS1 input)
Headphones
(to front-panel headphone output)
To Next Page
Loading...
Need help?
General
