Akai MPCX

208
Phasers
The phaser is a classic effect, created by multiple ganged all-pass filters to create “notches,” or sharp spikes, in the
frequency spectrum. The frequencies of these all-pass filters are usually modulated by an LFO to create a sweeping
sound.
Options: Phaser 1, Phaser 2, Phaser Sync
Phaser 1
Parameter
V
alue Range Default Value
Dry/Wet 0
–
100 (dry–wet) 100
Rate 0
–
100 10
Phaser 2
Parameter
V
alue Range Default Value
Dry/Wet 0
–
100 (dry–wet) 100
Rate 0
–
100 10
Phaser Sync
Parameter
V
alue Range Default Value
Dry/Wet 0
–
100 (dry–wet) 100
Rate 1 bar
–
1/16 triplets 1/4
HP (High-Pass) Filters
Options: HP Filter, HP Filter Sweep, HP Filter Sync, HP Shelving Filter
HP Filter
This effect is a static filter without modulation.
Parameter
V
alue Range Default Value
Frequency 10
–
19999 Hz 1500
Resonance 0
–
100 0
HP Filter Sweep
This effect is a high-pass filter with its cutoff frequency
modulated by an LFO.
Parameter
V
alue Range Default Value
Dry/Wet 0
–
100 (dry–wet) 80
Low Frequency 0
–
100 50
High Frequency 0
–
100 100
Resonance 0
–
100 33
Rate 0
–
100 10