180
Returns
Pads, programs, and audio tracks can each be sent to up
to four send channels. Their audio signals will be routed to
the send channels at their designated send levels. After
being processed by the effects on those channels, their
signals are then sent back based on their return settings
(levels, panning, etc.). This view displays the four return
channels. The return mixer shows levels, panning, mute
states, insert effects, and routing for all used tracks.
To view a specific setting on all returns, tap Level, Pan,
Mute, Insert, or Route at the bottom of the touchscreen.
You can tap Insert multiple times to cycle through the four
available slots.
When a return is selected, you can view and adjust all of its
settings in the left side of the touchscreen rather than using
the tab buttons at the bottom.
When viewing the return channel strip:
The first field shows the current return number (which
you can change).
The second field shows where the return is routed
(which you can change).
The Inserts field shows any enabled or disabled effects
for that return. Tap the area under Inserts to open a
window where you can load, change, and enable or
disable the effects.
Tap Mute to mute the return.
Adjust the pan knob or level slider to change the
panning or level of the return.
To Next Page
Loading...
Need help?
General
