196
Pad Parameters
In the Pad Parameters Q-Link Edit Mode, the Q-Link knobs control the same pad parameter for the each of the 16
pads in the current pad bank.
For example, if the Parameter is set to Level, the 16 Q-Link knobs will adjust the 16 independent Level settings for
each pad in the current pad bank. You could then set the Parameter to Pan and use the Q-Link knobs to adjust the
panning of all 16 pads.
Next to the top row of Q-Link knobs in the touchscreen, tap one of these tabs to select the type of parameter you
want to control with the Q-Link knobs:
Mixer: general mixer parameters
Program: pad parameters (i.e., parameters used in Program Edit Mode)
Use the Parameter field to select the parameter you want to control with the Q-Link knobs.
Tap the Momentary checkbox to turn momentary behavior on or off.
When on, moving the Q-Link knob will adjust its parameter, but the parameter will immediately return to its original
position (when you turned Momentary on) when you release the Q-Link knob.
When off, moving the Q-Link knob will adjust its parameter, and the parameter will remain at its new setting when
you release the Q-Link knob.
To Next Page
Loading...
Need help?
General
