185
To get the most efficient use of the Browser, set the file paths to
your favorite drive locations first. There are five folder buttons
labeled 1–5 in the upper-right corner. You can set these to be
shortcuts to five locations on MPC X’s internal drive and/or any
connected USB drives or SD cards, giving you quick access to
your files.
To assign the current location to a folder button, press and
hold Shift, and then tap one of the folder buttons (1–5). Now,
when you tap that folder button again, the Browser will show that
folder’s content immediately.
Use the six filter buttons to show only specific types of files in the
list below.
To show project files only, tap the P/page icon.
To show sequence files only, tap the bars icon.
To show program files only, tap the four-squares icon.
To show sample files only, tap the waveform icon.
To show all file types, tap the three-pages icon.
To show or hide MPC project folders, tap the MPC folder icon.
Use the six Content buttons to show specific locations in MPC
X’s internal drive and filter them automatically by file type:
Drums: Tap this button to enter the Expansions/The Vault 2
folder on the internal drive, viewing program files only.
Instruments: Tap this button to enter the Expansions/
Instruments folder on the internal drive, viewing program files
only.
Clips: Tap this button to enter the Expansions/Cliips folder on
the internal drive, viewing program files only.
Samples: Tap this button to enter the Expansions/The Vault 2
folder on the internal drive, viewing sample
files only.
Demos: Tap this button to enter the Demos folder on the
internal drive, viewing project files only.
My Files: Tap this button to enter the MPC Documents folder,
viewing all files.
To Next Page
Loading...
Need help?
General
