63
Audio Tracks
You can load up to four insert effects to each audio track. You can do this in Main Mode and the Channel Mixer.
To load an audio track insert effect in Main Mode:
1. When the Audio tab is selected (in the lower-left corner),
use the Track field to select the audio track.
2. If the channel strip is not already shown, tap the small
eye icon below the Project field to show it.
3. Tap the waveform icon at the top of the channel strip.
The channel strip will now show settings for the current
audio track.
4. Tap the area under Inserts, and then use the screen that
appears to load or edit effects.
To load an audio track insert effect in the Channel Mixer:
1. Set the Mixer field in the upper-left corner to Audio
Tracks.
2. In the touchscreen, tap the pad that corresponds to the
desired audio track.
3. Tap the area under Inserts, and then use the screen that
appears to load or edit effects. Alternatively, tap the
Insert tab at the bottom of the touchscreen (tap it
multiple times to select a different insert slot), and then
double-tap the desired pad in the touchscreen. You
could also use the data dial or –/+ buttons to select an
effect immediately.
To Next Page
Loading...
Need help?
General
