74
Use the Events selector to set the target range for the time
correction. You can apply the time correction to All note
events or to just the Selected ones. When Range is
selected, you can define the locations (From and To) as
well as the pads or keys that will be quantized.
The Click/Metro menu contains all settings regarding the
metronome (click track).
To open the metronome settings, tap the Metro/
metronome icon at the top of the touchscreen.
Use the Count-In field to set if/when the metronome
counts before recording.
Off disables the metronome pre-count.
Record enables the pre-count during recording only.
Record + Play enables pre-count in both Record and
Playback Modes.
Use the Enable field to set if/when the metronome is
enabled.
Off disables the metronome.
Play enables the metronome sound during playback only.
Record enables the metronome sound during
recording only.
Record + Play enables the metronome to happen in
both Record and Playback Modes.
Use the Rate field to select the metronome click’s time
division: 1/4, 1/4T, 1/8, 1/8T, 1/16, 1/16T, 1/32 or 1/32T.
T
indicates a triplet-based time division.
Use the Sound field to select the sound that you want to
hear for the metronome: Sidestick 1, Sidestick 2, Clap,
Metroclick, Shake, Tambourine, or MPC Click.
Use the Volume knob to set the volume of your metronome
click.
Tap the On/Off button to enable or disable the metronome.
The automation button indicates the global automation
state. This is shown in several modes. See General
Features > Automation to learn about this.
To Next Page
Loading...
Need help?
General
