Version 1.21 107
s5000
/
s6000
EDIT PROGRAM
KG PITCH/AMP
Pressing KG PITCH/AMP in either the MAIN or KEYGROUP pages will show something like this:
The parameters are:
SEMITONE TUNE This allows you to tune the keygroup in semitone steps.
FINE TUNE This allows you to fine tune the selected keygroup.
KEYGROUP LEVEL This sets the overall level of the keygroup. The range is +/-30dB.
You will note that this level control is
after
the filter and so cannot be
used to reduce level to the filter to prevent distortion if high resonance is
used. For that, use the filter’s ATTENUATION parameter. However, the
KEYGROUP LEVEL is useful when you have maybe used
ATTENUATION on the filter - the KEYGROUP LEVEL can be used to
bring the attenuated signal back up.
PITCH MOD 1/2 Here you may set pitch modulation levels for the selected keygroup.
You may also select a controller for the two pitch mod inputs by pressing
the soft key again to move the cursor to the controller field. Use the
DATA wheel to select the controller.
AMP MOD Here you may set amplitude modulation levels for the selected keygroup.
You may also select a controller by pressing the soft key again to move
the cursor to the controller field. Use the DATA wheel to select the
controller.
GOTO SOURCE This will take you directly to the selected controller’s page. Of course, a
mod input needs to be selected for this.
To Next Page
Loading...
Need help?
General
