Version 1.21 223
s5000
/
s6000
UTILITIES
MIDI SETUP
This sets up how the S6000 will respond to MIDI. Pressing MIDI SETUP shows this screen:
The parameters are:
PROGRAM CHANGE This applies to remote program selection of programs via MIDI within
parts. It may be switched ON or OFF
MULTI SELECT This allows you to select whether MIDI program change or MIDI bank
change will remotely select multis. Multis may be given MIDI program
numbers in the RENUMBER MULTI page. If BANK is selected, the same
MIDI program numbers are used. Thus, sending a command to change
to bank 2 will cause the multi with MIDI program number 2 to be selected.
MULTI SLCT CH This sets the channel for the reception of program change commands
for remote selection of multis. Of course, this parameter has no effect if
MULTI SELECT is not switched on.
NOTE: When MULTI SELECT is switched on, the selected MIDI channel cannot be used to
remotely select programs in parts. For example, if MIDI channel 16B is selected for remote
selection of multis, you cannot select programs on that channel. This is done automatically.
To Next Page
Loading...
Need help?
General
