Version 1.21 7
s5000
/
s6000
INTRODUCTION
REMOVING THE PANEL (S6000 ONLY)
To remove the S6000 front panel, turn the two chrome ‘thumb screws’ found top left and right of the
panel counter clockwise until they feel very loose.
Using the recessed finger grips either side of the panel, with a gentle but firm action, pull the top of
the panel forward:
Try not to use too much force. Now lift the panel up and out of the recess.
If the panel does not come away, check the ‘thumbscrews’ in case one or both of them are still
attached to the main case.
To attach the panel, simply do the reverse.
REMOVABLE PANEL CABLE LENGTH
The S6000 is supplied with a short cable for packing and transportation purposes. This allows the
S6000 to be used immediately with the removable panel attached to the main chassis. If you wish
to use a longer cable, you need a simple 9-pin > 9-pin (female to female) extension lead. These
are readily available in most computer stores.
The maximum recommended length is 10 metres. If you use a cable longer than this, you may
experience unreliable operation.
If you have any difficulty obtaining such a cable, please contact your AKAI professional dealer.
To Next Page
Loading...
Need help?
General
