Version 1.21 147
s5000
/
s6000
EDIT SAMPLE
PLAY TO This allows you to play to the currently selected edit point (i.e. with the
START parameter selected, it will play to the start point; with the END
parameter selected, it will play to the end point).
An edit point must be selected for the PLAY TO function to work.
PLAY FROM This allows you to play from the currently selected edit point (i.e. with
the START parameter selected, it will play from the start point; with the
END parameter selected, it will from the end point).
An edit point must be selected for the PLAY FROM function to work.
ZOOM IN/OUT This allows you to zoom in on the main waveform display. The ‘overview’
(i.e. the upper, smaller waveform display) always displays the full sample
regardless of the zoom factor. The waveform display style (LOG or LIN)
is shown between the keys (see later - SAMPLE TOOLS).
NOTE: Either the START or END points need to be selected for the zoom function to work.
TRIM SAMPLE This displays the following pop-up menu:
The options are:
DISCARD This will discard audio before the TRIM start point and after the TRIM
end point.
LOOP START>END This will discard audio either side of the loop (if one is set).
START>LOOP END This will discard audio before the TRIM start point and after the LOOP
END point.
CANCEL This closes the pop-up should you change your mind.
Pressing one of these will initiate the selected TRIM function. You will see the usual “Processing
sample” progress display followed by the PLAY/KEEP ORIGINAL/NEW/BOTH and RENAME
prompt
12
.
12 The process may be so fast that you may not see a progress display, especially on shorter
samples.
To Next Page
Loading...
Need help?
General
