270 Version 1.21
APPENDIX F
s5000
/
s6000
NOTES REGARDING INSTALLATION:
If you plan to install memory, please be aware that memory chips are sensitive to static electricity
so observe the following precautions:
• Isolate the S5000/6000 by disconnecting it from the mains or your mixer/amp/whatever
before installing the board(s).
• The SIMMs may come with a special wrist strap to discharge static electricity. It is highly
recommended that you attach the strap to the S5000/6000’s case and to your wrist. If a
wrist strap or any other such accessory is not supplied, try discharging any static by touching
an earthed metal object before handling the boards.
• Always handle the memory board by its edges - avoid touching the components on the
board.
• To minimise static electricity, avoid carpeted areas (especially synthetically carpeted areas)
and low humidity areas.
• Under no circumstances should you force the boards into their slots. Should you do so, you
could damage the memory boards and/or the sampler’s motherboard.
Please note that user installation will invalidate your warranty and it is recommended that you
only use an AKAI professional authorised service centre to install memory boards. AKAI
professional M.I. Corp. does not guarantee against the unit’s malfunction, damage or any loss
resulting from user installation of memory boards. Neither can AKAI professional be liable for
damage caused to memory boards or the S5000/S6000’s circuitry by user installation.
To Next Page
Loading...
Need help?
General
