Alcatel-Lucent 7705 SAR-8 - Page 178

SNMP Command Reference
Page 178 7705 SAR OS System Management Guide
security-level auth-no-privacy — specifies that authentication is required but privacy (encryption)
is not required. When this option is configured, both the group and the user must be configured
for authentication.
security-level privacy — specifies that both authentication and privacy (encryption) is required.
When this option is configured, both the group and the user must be configured for
authentication. The user must also be configured for privacy.
context context-name — specifies a set of SNMP objects that are associated with the context-name
The context-name is treated as either a full context-name string or a context-name prefix
depending on the keyword specified (exact or prefix).
prefix-match — specifies the context-name prefix-match keywords, exact or prefix
Default exact
read view-name-1 — specifies the keyword and variable of the view to read the MIB objects.
This command must be configured for each view to which the group has read access.
Values up to 32 characters
write view-name-2 — specifies the keyword and variable of the view to configure the contents of the
agent. This command must be configured for each view to which the group has write access.
Values up to 32 characters
notify view-name-3 — specifies the keyword and variable of the view to send a trap about MIB
objects. This command must be configured for each view to which the group has notify access.
Values up to 32 characters
attempts
Syntax attempts [count] [time minutes1] [lockout minutes2]
no attempts
Context config>system>security>snmp
Description This command configures a threshold value for the number of unsuccessful SNMP connection
attempts allowed in a specified time frame. The command parameters are used to counter denial of
service (DOS) attacks through SNMP.
If the threshold is exceeded, the host is locked out for the lockout time period.
If multiple attempts commands are entered, each command overwrites the previously entered
command.
The no form of the command resets the parameters to the default values.
Default attempts 20 time 5 lockout 10