Log Command Reference
Page 262 7705 SAR OS System Management Guide
event-id — the event ID, expressed as a decimal integer
Values 1 to 4294967295
router
Syntax router {eq | neq} router-instance [regexp]
no router
Context config>log>filter>entry>match
Description This command specifies the log event matches for the router.
Parameters eq — determines if the matching criteria should be equal to the specified value
neq — determines if the matching criteria should not be equal to the specified value
router-instance — specifies a router name up to 32 characters to be used in the match criteria
regexp — specifies the type of string comparison to use to determine if the log event matches the
value of router command parameters. When the regexp keyword is specified, the string in the
router command is a regular expression string that will be matched against the subject string in
the log event being filtered.
When regexp keyword is not specified, the subject command string is matched exactly by the
event filter.
severity
Syntax severity {eq | neq | lt | lte | gt | gte} severity-level
no severity
Context config>log>filter>entry>match
Description This command adds an event severity level as a match criterion.
Only one severity command can be entered per event filter entry. When multiple severity commands
are entered, the last command overwrites the previous command.
The no form of the command removes the severity match criterion.
Default no severity
To Next Page
Loading...
