Monitor CLI Commands
Page 108 7750 SR OS Basic System Configuration Guide
lsp-ingress-statistics
Syntax lsp-ingress-stats lsp lsp-name sender sender-address [interval seconds] [repeat repeat]
[absolute | rate]
Context monitor>router>mpls
Description This command displays ingress statistics for LSP interfaces at the configured interval until the config-
ured count is reached.
Parameters repeat repeat — Specifies how many times the command is repeated.
Values 10
Values 1 — 999
interval seconds — Specifies the interval for each display, in seconds.
Values 10
Values 3 — 60
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead
of the delta.
Sample Output
B:Dut-C-cpm2# monitor router mpls lsp-ingress-stats lsp sample 1.1.1.1 repeat 3
interval 10 absolute
===============================================================================
Monitor ingress statistics for MPLS LSP "sample"
-------------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
LSP Name : sample
Sender : 1.1.1.1
-------------------------------------------------------------------------------
Collect Stats : Enabled Accting Plcy. : None
Adm State : Up PSB Match : True
FC BE
InProf Pkts : 539 OutProf Pkts : 0
InProf Octets : 548702 OutProf Octets: 0
FC L2
InProf Pkts : 0 OutProf Pkts : 539
InProf Octets : 0 OutProf Octets: 548702
FC AF
InProf Pkts : 0 OutProf Pkts : 0
InProf Octets : 0 OutProf Octets: 0
FC L1
InProf Pkts : 1078 OutProf Pkts : 0
InProf Octets : 1097404 OutProf Octets: 0
FC H2
InProf Pkts : 0 OutProf Pkts : 539
InProf Octets : 0 OutProf Octets: 548702
FC EF
InProf Pkts : 539 OutProf Pkts : 0
To Next Page
Loading...
Need help?
General
