Alcatel-Lucent 7750 SR OS Basic User Manual

Common Configuration Tasks
Page 282 7750 SR OS Basic System Configuration Guide
Configuring Power Supply Parameters
By default, 7750 SR-Series routers are configured as DC-input devices. Traps and alarms are
automatically sent if DC power supplies are installed in the power supply slots. In order to
generate traps and alarms when AC power supplies are installed in 7750 SR-Series models (except
the non-redundant models) the power-supply command must be modified. In the non-redundant
models, the power supply parameters cannot be modified.
Configuring an existing power supply to none prior to powering off the unit will prevent an alarm
from being generated.
There are two power supply positions on the 7750 SR-c12.See the SR-Series-XX Hardware
Installation Guides for instructions to install power supplies.
Use the CLI syntax displayed below to modify power supply parameters.
CLI Syntax: config>system
power-supply {1|2} {dc|ac {single|multiple}|none}
Example
: config>system# power-supply 1 dc
config>system# power-supply 2 dc
The following example displays the power-supply command configuration:
A:ALA-12>config>system# info
-----------------------------------------------------------------
..
name "ALA-12"
contact "Fred Information Technology"
location "Bldg.1-floor 2-Room 201"
clli-code "abcdefg1234"
coordinates "N 45 58 23, W 34 56 12"
power-supply 1 dc
power-supply 2 dc
lacp-system-priority 1
sync-if-timing
begin
ref-order ref1 ref2 bits
ref1
shutdown
exit
ref2
shutdown
exit
bits
shutdown
interface-type ds1 esf
exit
commit
exit
..
-----------------------------------------------------------------

Alcatel-Lucent 7750 SR OS Basic Specifications

General

Brand	Alcatel-Lucent
Model	7750 SR OS Basic
Category	Network Router
Language	English