System Administration Parameters
Page 286 7750 SR OS Basic System Configuration Guide
Set-time
Use the set-time command to set the system date and time. The time entered should be accurate
for the time zone configured for the system. The system will convert the local time to UTC before
saving to the system clock which is always set to UTC. If SNTP or NTP is enabled (
no
shutdown
) then this command cannot be used. The set-time command does not take into account
any daylight saving offset if defined.
CLI Syntax: admin
set-time date time
Example
: admin# set-time 2007/02/06 04:10:00
The following example displays the set-time command results.
ALA-2# admin set-time 2007/02/06 04:10:00
ALA-2# show time
Thu Feb 2 04:10:04 GMT 2007
ALA-2#
Display-config
The display-config command displays the system’s running configuration.
CLI Syntax: admin
display-config [detail] [index]
Example
: admin# display-config detail
The following example displays a portion of the display-config detail command results.
A:ALA-12>admin# display-config detail
# TiMOS B-0.0.I326 - Copyright (c) 2000-2006 Alcatel.
# All rights reserved. All use subject to applicable license agreements.
# Built on Wed Mar 3 21:44:25 PST 2004 by builder in /rel0.0/I326/panos/main
# Generated SAT MAR 06 03:20:06 2004 UTC
exit all
configure
#------------------------------------------
echo "System Configuration"
#------------------------------------------
system
name "ALA-12"
contact "Fred Information Technology"
location "Bldg.1-floor 2-Room 201"
clli-code "abcdefg1234"
To Next Page
Loading...
Need help?
General
