Alcatel-Lucent 7750 SR OS Basic User Manual

Boot Option Files
7750 SR OS Basic System Configuration Guide Page 179
Deleting BOF Parameters
You can delete specific BOF parameters. The no form of these commands removes the parameter
from configuration. The changes remain in effect only during the current power cycle unless a
save command is executed. Changes are lost if the system is powered down or the router is
rebooted without saving.
Deleting a BOF address entry is not allowed from a Telnet session.
Use the following CLI syntax to save and remove BOF configuration parameters:
CLI Syntax: bof# save [cflash-id]
Example
: A:ALA-1# bof
A:ALA-1>bof# save cf3:
A:ALA-1>bof#
CLI Syntax: bof#
no address ip-address/mask [active | standby]
no autonegotiate
no console-speed
no dns-domain
no li-local-save
no li-separate
no primary-config
no primary-dns
no primary-image
no secondary-config
no secondary-dns
no secondary-image
no static-route ip-address/mask next-hop ip-address
no tertiary-config
no tertiary-dns
no tertiary-image

Alcatel-Lucent 7750 SR OS Basic Specifications

General

Brand	Alcatel-Lucent
Model	7750 SR OS Basic
Category	Network Router
Language	English