Alcatel-Lucent 7750 SR OS Basic - Page 123

Root Commands
7750 SR OS Basic System Configuration Guide Page 123
*A:ALA-12>config# port bpgrp-ima-1
*A:ALA-12>config>service>vpls$ sap bpgrp-ima-1
qtag1, qtag2 — Specifies the encapsulation value used to identify the SAP on the port or sub-port. If
this parameter is not specificially defined, the default value is 0.
Values qtag1: 0 — 4094
qtag2 : * | 0 — 4094
The values depends on the encapsulation type configured for the interface. The following table
describes the allowed values for the port and encapsulation types.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the absolute rate-per-second value for each
statistic is displayed.
Port Type Encap-Type Allowed Values Comments
Ethernet Null 0 The SAP is identified by the port.
Ethernet Dot1q 0 — 4094 The SAP is identified by the 802.1Q tag on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
Ethernet QinQ qtag1: 0 — 4094
qtag2: 0 — 4094
The SAP is identified by two 802.1Q tags on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
SONET/SDH IPCP - The SAP is identified by the channel. No BCP is
deployed and all traffic is IP.
SONET/SDH
TDM
BCP-Null 0 The SAP is identified with a single service on the
channel. Tags are assumed to be part of the customer
packet and not a service delimiter.
SONET/SDH
TDM
BCP-Dot1q 0 — 4094 The SAP is identified by the 802.1Q tag on the channel.
SONET/SDH
TDM
Frame Relay 16 — 991 The SAP is identified by the data link connection
identifier (DLCI).
SONET/SDH
ATM
ATM vpi (NNI) 0 — 4095
vpi (UNI) 0 — 255
vci 1, 2, 5 — 65535
-
The SAP is identified by port or by PVPC or PVCC
identifier (vpi, vpi/vci, or vpi range)