Alcatel-Lucent 7750 SR OS Basic User Manual

Common Configuration Tasks
Page 172 7750 SR OS Basic System Configuration Guide
assign an IP address for this system.
The IP address should be entered in standard
dotted decimal form with a network length.
example: 192.168.xx.xxx/24
Displays
onno n-
Redundant
Models l
The existing IP address is 192.168.xx.xxx/20. Press ENTER to keep it.
Enter IP Address:
Using: 192.168.xx.xxx/20
Display on
Redundant
models
The existing Active IP address is 192.168.xx.xxx/20. Press ENTER to keep it.
Enter Active IP Address:
Using: 192.168.xx.xxx/20
The existing Standby IP address is 192.168.xx.xxx/20. Press ENTER to keep it.
Enter Standby IP Address (Type 0 ifno ne desired):
Using: 192.168.xx.xxx/20
Would you like to add a static route? (yes/no) y
Static Routes
-------------
You specified network locations which require
static routes to reach. You will be asked to
enter static routes until all the locations become
reachable.
Static routes should be entered in the following format:
prefix/mask next-hop ip-address
example: 192.168.xx.xxx/16 next-hop 192.168.xx.xxx
Enter route: 1.x.x.0/24 next-hop 192.168.xx.xxx
OK
Would you like to add another static route? (yes/no) n
New Settings
------------
primary-image ftp://vxworks:vxw0rks@192.168.xx.xx/./rel/0.0/xx
primary-config cf3:/config.cfg
address 192.168.xx.xx/20 active
primary-dns 192.168.xx.xx
dns-domain xxx.xxx.com
static-route 1.x.x.0/24 next-hop 192.168.xx.xxx
autonegotiate
duplex full
speed 100
wait 3
persist off
Do you want to overwrite cf3:/bof.cfg with the new settings? (yes/no): y
Successfully saved the new settings in cf3:/bof.cfg

Alcatel-Lucent 7750 SR OS Basic Specifications

General

Brand	Alcatel-Lucent
Model	7750 SR OS Basic
Category	Network Router
Language	English